Degas injection into the cylinder middle part "Degas Hale" the material moisture generated during melting, gas and residual control over mono (Monomer) is discharged. On the other hand dryer to dry only the surface moisture of the raw material, an injection cylinder is Degas any gas generated during melting of the raw materials provides the best solution for high-quality forming, since the discharge.
VENT UP (resin full issue)
- A & B of the balance is critical (depending on the molding conditions)
- That the material inlet port is always full (full)
DEGRADATION & COLOR CHANGE
- A & B of the city depending on the pressure-balance some of the resin is likely to be plenty congestion
- Some defects are the cause of the resin sticking to the screw
Raw material supply controlled via the camera
Preventing stagnation of material in the pressure-sensitive region
Nihon Organic screw design patents
Injection collected: 200
General Injection
Injection collected: 400
GAS injection remove